Documentation Description

KZR-DOC-02 Rev. 00 06.10.2024 PDF

Foreword

Kezar Engineering is an engineering company that operates globally and haves its headquarter in Brazil. We aren’t equipment manufacturer and the list of services provided by us can be found in our website https://kezareng.com. Our specifications and templates are public available as part of our Open Knowledge Program and available under Creative Commons Attribution 4.0 International License (CC BY-NC-ND 4.0).

Introduction

1. Scope

2. Documentation List

2.1. Created by Kezar Engineering

The list below contains the documents that we're capable of creating, it doesn't mean that all this documents will be created in every project. These documents are created by request and are always specified in the Quotation (KZR-QTN-01).

  • General Arrangement Drawing (GAD) - main equipment drawing which must shown, among other things:
    • Elevation and orientation of all nozzles
    • Elevation and orientation of the legs
    • Overall dimensions (total height and width)
  • Detail Drawing (DET) - this is also called fabrication drawing and must have all the information needed to manufacture the equipment. Sometimes it's divided in several other drawings:
    • Name Plate drawing (NPD) - as the name says, it's the drawing with manufacture information for the name plate. Some companies have a standard or template drawing for the name plate.
    • Davit Arm Drawing (DVT) - drawing showing davit arm with all its parts: support plate, guide plate, arm (made of pipe or round bar), gusset plate, lugs, eye bolt, nuts, washer, pad and welds. See KZR-SDS-02
    • Support Drawing (SPD) - drawing showing the vessel supports with all its parts and welds. Support can be legs (made or structural shapes or pipes), saddles or skirt.
    • Internals Drawing (INT) - drawing showing all parts (which isn't welded to the pressure parts) assembled inside the vessel (e.g. demisters and filter cartridges)
    • Bill of Material (BOM) - see KZR-DSG-04
  • Quotation (QTN) - document with description, quantity, price and delivery date of the service(s) to be performed (see KZR-QTN-01) by Kezar Engineering.
  • Datasheet (DTS)- document with customer, equipment and process data (e.g. tag, fluid, operating and design pressure, materials, nozzles, etc)
  • Installation and Operating Manual (IOM) - as the name says, this document contain all information needed to install the equipment and put it in operation. If the equipment isn't entirely design by Kezar Engineering, then, this document must be created with information from both sides (Kezar Engineering & Customer)
  • Spare Part List (SPL) - list of spare parts needed by the equipment. Usually there are three situations that should be considerated:
    • Commissioning / Installation
    • One Year Operation
    • Two Years Operation

2.2. Created by the Customer

  • Customer Specifications (CSP) - xxx
  • Customer Datasheet (CDS) - xxx

2.3. Created by the End User

  • End User Specifications - xxx
  • End User Datasheet (EDS) - xxx

2.4. Created by the Manufacturer

  • As Built Drawings (ABD) - xxx
  • Weld Map (WDM) - xxx

3. Disclaimer

This specification was created to be used by Kezar Engineering company but, as stated in the Foreword, we have made it available for public use.

When used by a company/person other than Kezar Engineering, the company/person agrees that Kezar Engineering shall not be held liable for any damages, losses, or negative outcomes arising from the use, misuse, or misinterpretation of the information provided in the specification. The company/person is solely responsible for verifying the suitability of the specification for their intended application and assumes all risks associated with its use.